Full-Frame Window Replacement

Full-Frame Window Replacement in Buffalo

Full-frame replacement removes the entire old window down to the rough opening, including the frame, sill, and trim. That is the method to use when the framing is rotted, the flashing has failed, or you want to change the size of the opening. Adamsbevgroup fabricates and installs full-frame units across Buffalo, from the West Side doubles to newer homes near 14216.

Why Choose Full-Frame

Older Buffalo homes hide a lot behind the trim. Decades of freeze-thaw and wind-driven rain off Lake Erie can rot a sill or corrode old flashing, and an insert window would simply cover the damage. Going full-frame lets us inspect the studs, replace bad wood, and lay fresh flashing tape before the new fiberglass or vinyl unit ever goes in. It is also the only clean way to enlarge an opening to meet the 5.7 square foot IRC R310 egress minimum.

Our Process

We measure the rough opening, remove the old window and any failed framing, and dry-fit the new unit square and plumb. Warm-edge spacers, argon-filled low-E glass, and expanding foam insulation go in to the NFRC target, then we finish the interior and exterior trim. When a permit applies, we pull it and meet the inspector.

Call (716) 794-8340 for a free quote on full-frame window replacement in Buffalo.